Things turn even further in the favor of the ASW system if you factor in punctures, blowouts, tire fires and how long a truck has to be out of service each year while those monster tires get changed. ASW treads are bolt-on, bolt-off chunks that can be changed with very little gear, without even jacking any wheels up, and done in sections during shift changes and lunch breaks so the truck's never out of service due to tires. They can also ship much more cheaply, since the whole assembly can be broken down into bits that easily fit in a regular shipping container.
OK, after pouring through much of the other thread, I felt I spent so much time looking at setups that weren't relevant to what I was looking to do...which is stay on stock suspension. So this thread is dedicated to Aftermarket wheels on stock suspension. *List wheel make and model with offset and width as well as tire make/model/size. *Try to take pics showing "poke." That means refrain from turning the front wheels for the pics. Keep 'em pointed straight and try to get some shots down the side of the car that will help others make a decision. *If you've rolled, pulled fenders and/or used the slotted strut mounts for more tire/fender clearance that is ok, just let us know when you post your setup.

Fittings, unless noted, are made from hot-rolled, pickled and oiled steel plates, bar, strip or coil, and conform to one or more of the following specifications: ASTM specifications A575, A576, A635, A1011 SS GR 33, A1011 HSLAS GR 45 or A36. All fittings meet or exceed physical properties of ASTM A1011 GR 33. The pickling of the steel produces a smooth surface free from scale. Many fittings are also available in stainless steel, aluminum and fiberglass. Consult factory for ordering information. Green Powder Coat (GR), conforming to commercial standards for Powder Coating Electro-galvanized (EG), conforming to ASTM B633 Type III SC1 Hot-dipped galvanized (HG), conforming to ASTM A123 or A153 Plain (PL) Unistrut Defender (DF), conforming to ASTM A1059 or A1046
I started to remove the bike and it came out easily. I began removing the padding and cutting zip ties. Everything looked great although I was a bit concerned as there were no instructions included. Upon further unpacking, I could easily see there were minor steps to assembly which became self explanatory. I screwed in the right peddle and a small bearing fell into my hand. I called the number on the bike and explained the situation. In under 10 mins, a new peddle was on its way free of charge. I completed the assembly and took it for a test drive. The bike felt solid and drove like a champ! This is going to be a fun bike to use on the trails!! Bike arrived yesterday, so I put it together last night, and attempted to ride it. The gears don't change properly, and the chain constantly runs on the chain guard. Tries to adjust the gears, but to no avail. I got it close but either the chain runs while pedalling l, or the gears don't move to the next sprocket when the trigger is pulled... I'm going to try again tonight after work, bit I'd like to talk to the seller a out this issue.... a brand new bike out of the box should change gears.... I think.