Seems like a lot of the aftermarket wheels are on lowered Supras, anybody here running aftermarket wheels with stock suspension? Unfortunately with my driveway and roads, lowering may not be an option due to the possibility of scraping. I feel others may be in the same boat so this may be a helpful thread. Please share photos and specs of your aftermarket wheels/tires with stock suspension! First Name Sam Joined May 4, 2020 Messages 167 Reaction score 158 Location Houston Car(s) 2021 A91, 2008 S2000 CR, tow pigs First Name Dan Joined Oct 5, 2020 Messages 64 Reaction score 107 Location OH, US Car(s) '21 Supra 3.0 premium Gram Lights 57CR in gloss black: 19x9.5 +25, 19x10.5 +35 stock tires, stock suspension. Doubt I'll ever change it, but if I do, it'll be a minimal drop because I'm not getting any younger First Name Kyle Joined Jun 22, 2020 Messages 243 Reaction score 123 Location CA Car(s) 2020 A90 GR Supra, 1996 NA Miata, 2014 Camry SE but none the less, here is my contribution. still trying to figure out my fitment tho.. i dont think im going to lower my car (due to my driveway, which i already scrape on, and my daily drives) theyre ESR SR01 19x9.5 +22 front and 19x10.5 +22 on rears. I had to run a 12mm spacer in front to clear the caliper (which i thought it was going to clear, but sadly was wong) which made my rear fitment a bit weak compared to the front. so i had to compensate with a little 5mm spacer on the rear (still not sure whether to run a 5mm or 10mm spacer on the rear, i feel like 10mm would be really pushing it and will rub badly.) First Name Steve Joined Nov 21, 2020 Messages 593 Reaction score 574 Location Beaufort South Carolina Car(s) 2021 a91 edition Supra 2016 Lexus rc f BMW 435I imo Wheels should not poke out from the fenders...makes the car look like a 4 wheel drive...but each his own If so why not change the barrels for a more flush fit? Or were you going for a poke look? First Name Kyle Joined Jun 22, 2020 Messages 243 Reaction score 123 Location CA Car(s) 2020 A90 GR Supra, 1996 NA Miata, 2014 Camry SE If so why not change the barrels for a more flush fit? Or were you going for a poke look? i was going for a more "flush" look and its the only offset they offered. I thought i was going to clear upfront, and worried more with the rear. but it turned out the other way around.. and since the front poked out, i was trying to compensate on the rears. but i dont mind "a little" poke just not too much. oh well at least it looks decent
Loopwheels give a smoother ride on bumpy, uneven ground such as woodland tracks, cobbles, grass and beach as well as smoother surfaces like paths around town.

I might eventually drop it. You have remember though, the roadsters sit atleast a half inch lower than the coupes to begin with (stock). Here's mine on 19's. I'll probably cut down the spring seats to level it up a bit in the rear. Use a slightly taller tire. That helps alot. Mine are 275/35/19 and 285/35/19 and I love the way it looks on the stock suspension. Last edited by Firehawk; 02-26-2007 at 03:34 AM. with my roadster, i went from Eibach, to Hotchkis, and now waiting for Tein Htech to come in. I think Htech will be the perfect drop for me, LOL Even with 35 sidewall tires, the gap in stock suspension is horrible. There are a lot of good points that have been made in this thread. I think a big factor in your decision will be really the road conditions in your area. Lots of changes in slopes that cause you to bottom out would not be a good thing for a lowered vehicle. The cars I have seen here look quite good, mostly because they have either 19s or dubs on them.
The Hot Wheels Massive Loop Mayhem set is a great gift for kids 5+ who love the thrill of stunts, racing and crashing their Hot Wheels vehicles.