looking to get the same size and offset wheel and tires for stock Si (not planning to lower), will it work without rolling fenders? looking to get the same size and offset wheel and tires for stock Si (not planning to lower), will it work without rolling fenders? I think so. The minor hand pull I did front and rear was only for aesthetics. The rear wheels definitely gain a lot of neg camber when compressed so shouldn't be an issue there and the front should be fine as well. What you may want to take into account is the "rim protector" on certain tires is fairly aggressive on some (Continental Extreme Contact Sport) but not existent on others (Hankook V12 Evo2). If any amount of poke bothers you, then try to look at pictures of wheels and look for that. But I would again say that is more for aesthetics. But I would prob look into removing the locating pin on the upper strut mount up front first and adding in that little bit of neg camber for more clearance first.
ONDA terms itself a recumbent stunt bike/trike that can also be used to commute to work. Commute to work? What am I, the imp from Game of Thrones? Cee Lo Green? I'm not willingly placing a 3-foot-high version of myself...

The Loopwheels’ spring system between the hub and the rim cushions the rider from potholes and bumps in the road. It also reduces road noise by absorbing it, thereby reducing vibration through the frame—and into the rider’s arms and body. Because the suspension is inside the wheel, you don’t need fat tires to make the ride nicer. Instead, you can use high-pressure or puncture-resistant tires.
A set of ASW wheels, on the other hand, will cost you more upfront but last something like 13 times longer – out to the service life of the truck itself. Your first set of six wheels in this case will run you about $1.705 million, but over 10 years you'll likely only need two tread replacements at around $55,000 a pop, giving you a 10-year budget of $1.815 million and a $845,000 saving.